Table of Contents
Advertisement
9.8.11
CEC connection
Menu
Top→OUTPUT SETTING→CEC CONNECTION
Setting for
Each output channel (OUTA / OUTB)
Setting value
・NOT CONNECTED [Default]
・IN1 to IN8
You can set the CEC connection for when CEC-supported device is connected to HDMI input connector,
HDBaseT input connector, HDMI output connector, or HDBaseT output connector.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.
Notes:
・Using CEC may cause negative effects. If you do not use CEC, set this menu to "NOT CONNECTED". If the
status of the sink devices connected to the HDMI output connector changes (such as being turned OFF→
ON) or if the CEC connection changes, the EDID may also need to be changed (the MSD changes it
automatically) in order to update the address of the connected device. When the EDID is changed, the
source device stops outputting video temporarily.
・IN6 and IN7: CEC is not supported.
・CEC connection is a one-on-one basis; it cannot connect multiple inputs and outputs. If you set multiple
outputs to connect to the same input, only a smaller output number is connected preferentially and other
outputs are not connected.
9.8.12
HDCP re-authentication
Menu
Top→OUTPUT SETTING→HDCP AUTHORIZATION
Setting for
Each output channel (OUTA / OUTB)
If a sink device supporting HDCP is connected, HDCP is authorized automatically. You can re-authorize
HDCP manually using this menu (Connection Reset is performed automatically, but it can be performed
manually using this menu). Press the MENU/SET key to perform the re-authentication.
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
・SELECTED CHANNEL
73
Advertisement
Table of Contents
