Table of Contents
Advertisement
9.9
Audio setting
HDMI digital audio supports the following formats. Set audio depending on device connected to the HDMI
output connector.
Only "2 channel linear PCM" can be input by Factory default. If you want to use "Multi channel linear PCM" or
bit stream signal (compressed audio), set "Audio format" and "Speaker configuration".
Audio format
2 channel linear PCM
Multi channel linear PCM
AC-3, Dolby Digital, DTS, Dolby Digital+,
DTS-HD, Dolby TrueHD, AAC
■ If multi channel linear PCM signal input to digital audio:
If Multi channel linear PCM signal are input to digital audio, two channels set in "9.9.9 Multi channel audio
output" or down-mixed audio is output to analog audio and sink devices that do not support multi linear PCM.
Blu-ray disc player
■ If bit stream signal input to digital audio:
If bit stream signal (compressed audio) such as Dolby Digital is input to HDMI digital audio, these input audio
signals are output to digital audio as they are. They are not output to analog audio, and audio volume cannot
be adjusted.
Blu-ray disc player
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
[Table 9.9] Audio format
2ch, 32 kHz to 192 kHz, 16 / 20 / 24 bit
8ch, 32 kHz to 192 kHz, 16 / 20 / 24 bit
Bit stream
5.1ch
Digital input
Matrix Switcher
Input level
[Fig. 9.17] Multi channel linear PCM input
Bitstream signals
Switch
Digital input
Adjusting audio volume disabled
[Fig. 9.18] Bit stream signal input
【See: 9.10.6 Speaker configuration】
Description
5.1ch
Digital output
AV Amplifier supporting multi
channels
Selected 2 ch or down mixed audio
Analog output
Amplifier built in speaker
Any 2 ch or down mixed audio
Digital output
Output level
LCD monitor not supporting multi
channels
Digital output
AV Amplifier
Analog output
Analog audio not output
Amplifier built in speaker
【See: 9.10.5 Audio format】
77
Advertisement
Table of Contents
