Twisted Pair Cable For Extension - IDK MSD-702UHD User Manual

7.2.3 Twisted pair cable for extension

To ensure the best performance of twisted pair cables, select a correct twisted pair cable and connect it
correctly.
● Cat5e UTP/STP and Cat6 UTP/STP can be used, but we recommend CAT.5E HDC cable* for optimal
performance.
● If using an STP cable, connect the FG connector to a ground source. Otherwise, the shielding feature
does not work correctly. When using a UTP cable, we still recommend using the ground connector.
● The shielded STP cables are less affected by interference or external noise than UTP cables.
● Connectors for long-haul extension are the same as that of eight-core modular connector used for
Ethernet, but the transmission system is not the same so that it cannot be connected to Ethernet.
● The maximum extension distance of a twisted pair cables is the shorter distance of the maximum
extension distances of transmitter/receiver/sink device connected to the MSD.
● Pin assignments: T568A or T568B straight
● Do not pull the cable hard. The allowable tension of the twisted pair cable is 110 N.
● Do not bend the connection cable at a sharp angle. Keep the bend radius four times of the cable diameter
or larger.
● Do not tie the cable tightly; leave a space allowing the cable to move slightly.
● If you use multiple twisted pair cables, we recommended keeping a distance between the cables or not
to place the cables closely in parallel.
● Keep the twisted pair cable as straight as you can. If you coil the cable, it is easily affected by noise.
● Do not place the cable in an electrically noisy environment, since high-speed signals are transmitted.
Particularly when you use a high-output radio around the MSD, video or audio may be interrupted.
● If the total extension distance from the transmitter to receiver is 328 ft. (100 m) or less, up to two cable
joints can be used. Products supporting Cat6A (10GBase-T) are recommended. However, the extension
distance of high-resolution transmission, such as 4K, may be shortened about 10%.
● Use AWG 24 or ticker cable for PoH.
● The table below shows supported extension distance for each twisted pair cable category. Note that the
distance may shorten depending on the actual environment.
Noise Category
influence
Easily UTP
affected
Less STP
affected
*The CAT.5E HDC cable is a double-shielded twisted pair cable that optimizes video signal transmission.
It is certified to 500 MHz bandwidth at distance up to 330 feet (100 m) and verified to meet requirements
specified by HDBaseT Alliance. The double-shielded structure protects video signal from outside
interference.
Note:
If there is a problem in the transmission path, video or audio may be interrupted. Check the precautions above.
If the problem still cannot be solved, shortening the twisted pair cable may remedy the problem.
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
[Table 7.2] Twisted pair cable and extension distance
Extension
distance
Cat5e 164 ft.
(50 m)
Cat6 328 ft.
(100 m)
230 ft.
(70 m)
Cat5e* 328 ft.
Cat6 (100 m)
492 ft.
(150 m)
TMDS clock
≦ 225 MHz
> 225 MHz
(4K format)
Long reach mode
≦ 148 MHz
(1080p 24 bit or less)
Remarks
For 164 ft. (50 m) or longer,
Cat5e STP, Cat6 UTP / STP,
CAT.5E HDC* are
recommended.
For 4K format 230 ft. (70 m) or
longer, Cat5e STP, Cat6 STP,
CAT.5E HDC* are
recommended.
Cat5e STP, Cat6 STP,
CAT.5E HDC cable
23