Table of Contents
Advertisement
9.6.3 Analog input signal parameters
Menu
Top→INPUT SETTING→ANALOG INPUT TYPE
Setting for
Each input channel, each input signal (only analog input)
Setting value
・AUTO : Automatic [Default]
・RGB
: Analog RGB
・YPbPr : Analog YPbPr
You can set the signal type that is being presented to the DVI-I input connector.
If you select "AUTO", the type of input signals are detected automatically. In cases where the detection fails
and video is not output correctly, set the input type manually. With "AUTO", the automatic detection of
S-Video may fail. If both composite video and S-Video are input at the same time, select "VIDEO AUTO"; if
only S-Video is input, select "Y/C".
This menu is available only if an analog signals are present on input ports 6 or 7.
Note:
For video from a monochrome camera or VHS tape with in poor condition or the like, automatic detection may
fail. Under these circumstances, select "VIDEO AUTO", "VIDEO" or "Y/C".
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
・VIDEO AUTO : Video automatic
・VIDEO
: Composite video
・Y/C
: S video
【See: 9.6.5 Selecting signal of DVI input connector】
59
Advertisement
Table of Contents
