Table of Contents
Advertisement
Item
COM
RECV DISPLAY
yes
*1
DELIMITER
yes
*2
RCV CHECK
yes
*3 *4
TIME OUT
yes
*3 *4
RETRY
yes
*3 *4
INTERVAL
yes
*3 *4
ERROR
yes
Contact closure
no
control
Pulse width
no
HDMI CEC
no
*7
control
Process for CEC
no
error
MEMO
yes
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
[Table 9.22] Setting items of control command (Cont'd)
Setting
CC
CEC
no
no
Set whether received data is displayed or
not.
no
no
Set the delimiter to be sent at the end of the
received data.
"NONE": delimiter is not checked and all
received data within the set timeout will be
valid.
Value other than "NONE": delimiter is
checked and data received before delimiter
will be valid.
no
no
Set whether reply command that may be
returned is checked or not.
no
no
Set the timeout time for reply command to a
sent command.
no
no
Set the number of retries to resend the
same command again if no valid response
is replied.
no
no
Set the retry interval to resend the
command.
no
no
Set whether the next command is to be
executed or not if no valid response is
replied, even after completing retry for the
set number of retries.
yes
no
Set the contact closure control.
If you select "toggle operation", it can invert
the condition of contact (open/close).
yes
no
Set the time of returning its original
condition when you control the contact
closure.
no
yes
Set the CEC control for the sink devices
connected to OUT1A / OUT2A / OUT1B /
OUT2B.
Set whether the next command is executed
no
yes
or not if no response is replied from the sink
device that is controlled with CEC.
Register a note up to 14 characters.
yes
yes
The registered note is displayed when the
control command is executed.
Description
Range
OFF [Default]
ASCII
HEX
NONE [Default]
00 to FF (Hex)
CHECK
NOT CHECK [Default]
0ms to 99s999ms
[Default] 0ms
0 to 99 (times)
[Default] 0
0ms to 99s999ms
[Default] 0ms
STOP [Default]
EXEC: continue
-: not control [Default]
OFF: contact open
ON: contact close
TGL: toggle
NONE: eternity [Default]
100ms to 9990ms (by
10ms)
-: not control [Default]
POWER OFF
POWER ON
STOP [Default]
EXEC: continue
20 to 7D in ASCII codes
except for 2C (,)
[Default] 20 (space)
99
Advertisement
Table of Contents
