Table of Contents
Advertisement
9.8.7 Video output connector
Menu
Top→OUTPUT SETTING→OUTPUT CONNECTOR
Setting for
Each output channel (OUTA / OUTB)
Setting value ON [Default], OFF
The MSD distributes the same video to the HDMI output connector and HDBaseT output connector. You can
set the each connector to output the video or not.
This feature can be used for previewing video. You can check the one of video in one output while the other
output is set to "OFF".
9.8.8 HDCP
Menu
Top→OUTPUT SETTING→HDCP OUTPUT MODE
Setting for
Each output channel (OUTA / OUTB)
Setting value
HDCP 2.2
HDCP 1.4
HDCP INPUT ONLY : Encrypts HDPC only if input signal has HDCP
DISABLE
You can set the HDCP output for when a sink device supporting HDCP is connected.
Normally set this menu to "HDCP 2.2". The MSD encrypts optimal HDCP which HDCP 2.2 has priority.
If you select "HDCP 1.4", the MSD encrypts HDCP via HDCP 1.4 regardless which HDCP version the sink
devices have.
If you select "HDCP INPUT ONLY", the MSD encrypts HDCP only if the input signal has HDCP. However, if
input channel is changed to others and HDCP authentication status is changed, the MSD starts HDCP
authentication again. This action may take time to output video and audio.
If you select "DISABLE", the MSD never encrypts HDCP. Only the input signal which does not have HDCP
can be output.
If the sink device which does not support HDCP is connected, the MSD can output only the video and audio
which do not have HDCP regardless this menu.
Notes:
・HDCP2.2 (stream type 0) contents can be displayed on sink devices supporting HDCP1.4.
・HDCP2.2 (stream type 1) contents can be displayed on sink devices supporting HDCP2.2 but cannot be
displayed on sink devices supporting HDCP1.4.
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
: Encrypts HDCP via HDCP 2.2 [Default]
: Encrypts HDCP via HDCP 1.4
: Do not encrypt HDCP
71
Advertisement
Table of Contents
