Deleting A Block - IDEC SMARTRELAY User Manual

Closing the programming mode
hen you finish programming, you can exit the programming mode by following these steps:
1. Return to the programming menu: Press ESC
2. Return to the main menu: Press ESC
3. Move the cursor to
4. Confirm
IDEC SmartRelay is back in RUN mode:
3.7.8

Deleting a block

Consider the case where you want to delete the block B2 from your circuit program and
connect B1 directly to
To delete this block, follow these steps:
1. Switch IDEC SmartRelay to programming mode.
(As a reminder, refer to the topic The four golden rules for operating IDEC SmartRelay
(Page 57) ).
2. Select
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
: Press or
: Press O
1.
: Press or
Programming IDEC SmartRelay
3.7 riting and starting the circuit program
83