Inserting And Removing The Card From Idec Smartrelay - IDEC SMARTRELAY User Manual

9.2

Inserting and removing the card from IDEC SmartRelay

Do not remove a micro SD card while SmartRelay accesses the micro SD card.
hen you remove a micro SD card that contains a circuit program with copy protection
attributes, note the following: IDEC SmartRelay can only execute the circuit program stored
on the card if the card remains inserted during system runtime.
A removal of the card during RUN mode can lead to impermissible operating states.
Removing the micro SD card
To remove the micro SD card, carefully insert a screwdriver with a 3-mm blade into the
groove on the front of the socket, and lever the socket partially out of the slot. Press the two
sides of the socket and pull it out. ou can now remove the micro SD card from the card slot
on the left side of the socket.
Inserting the micro SD card
The entry of the card slot is chamfered on its bottom right. The edge of the cards is chamfered
accordingly. This encoding prevents you from inserting cards in the wrong way. Insert the
card into the socket, insert the socket into the slot and push it in until it engages.
Note
Make sure that you insert the card into the right position in the socket until you hear an
audible sound of a click.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
9.2 Inserting and removing the card from IDEC SmartRelay
Using memory cards
269