IDEC SMARTRELAY User Manual page 127

FL1F-RD1 function keys
The FL1F-RD1 has four function keys, F1, F2, F3, and F4, which you can use in your circuit
program. You program these keys in the same way as other inputs. Like the cursor keys, you
can press these keys when IDEC SmartRelay is in RUN mode to affect the behavior of the
circuit program, and to save switches and inputs.
Levels
Voltage levels are designated hi and lo. A constant "1" = hi or "0" = lo status at the block can
be set by means of a permanent voltage level or constant value hi or lo.
Open connectors
IDEC SmartRelay uses the letter x to indicate unused block connectors.
Network inputs/outputs (available only if configured from WindLGC)
You can configure the following network inputs/outputs only from WindLGC. If the circuit
program in IDEC SmartRelay contains a network digital/analog I/O, you can not edit any of
the rest of the circuit program except for the Par parameter. To edit the rest of the program,
you must upload the program to WindLGC and then edit from WindLGC.
1) Network digital inputs
The letters NI identify a network digital input. There are 64 digital network digital inputs NI1 to
NI64 available for configuration in the circuit program from WindLGC.
2) Network analog inputs
The letters NAI identify a network analog input. There are 32 network analog inputs NAI1 to
NAI32 available for configuration in the circuit program from WindLGC.
3) Network digital outputs
The letters NQ identify a network digital output . There are 64 network digital outputs NQ1 to
NQ64 available for configuration in the circuit program from WindLGC.
4) Network analog outputs
The letters NAQ identify a network analog output. There are 16 network analog outputs NAQ1
to NAQ16 available for configuration in the circuit program from WindLGC.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
IDEC SmartRelay functions
4.1 Constants and connectors
115