IDEC SMARTRELAY User Manual page 79

After you complete the change, press OK to confirm.
You then connect the block inputs as follows:
Press
Press
1", namely "I1". You can press
to select the desired input (I1 to I24).
Note
Inputs F1, F2, F3, and F4 correspond to the four function keys on the optional Text Display.
More shift register bits (S1.1 to S4.8), blank connectors (X1 to X64) and analog memory
markers (AM1 to AM64) are available in the FL1F device series.
Network digital inputs (NI1 to NI64), network analog inputs (NAI1 to NAI32), network digital
outputs (NQ1 to NQ64), and network analog outputs (NAQ1 to NAQ16) are available for the
FL1F device series. IDEC SmartRelay does not include these inputs and outputs until you
configure them in a circuit program in WindLGC V8.0 and download the program to your
IDEC SmartRelay.
After selecting I1, the display now shows as follows:
Press OK to confirm. You have now connected I1 to the input of the OR block.
Now you connect input I2 to the input of the OR block:
1. Move the cursor to In2: Press
2. Switch to editing mode: Press OK
3. Select the digital input list: Press
4. Move the cursor to the input number: Press
5. Select I2: Press
6. Apply I2: Press OK
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
to position the cursor on In1 and press OK to select editing mode.
or to select the digital input list. The first element of the digital input list is the "Input
or
3.7 Writing and starting the circuit program
to move the cursor to the input number, and then use
or
or
Programming IDEC SmartRelay
or
67