IDEC SMARTRELAY User Manual page 262

UDF (User-Defined Function)
Setting the Par parameter
ou can edit the Par parameter for your UDF block if you have configured parameters for this
UDF using
block contains the Par parameter, you can edit the parameters as described below:
View in programming mode (example):
1. Press
following display (T and TH are the identifiers you specified for the relevant UDF
parameters in
block using
single display.):
2. Press O and the cursor moves to the first number of T :
3. Press
or
shows the following display:
ou can also edit UDF parameter settings in parameter assignment mode in the same way as
you do in programming mode.
250
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
indLGC otherwise, you cannot edit parameters for UDF blocks. If your UDF
to move the cursor to Par and press O . IDEC SmartRelay shows you the
indLGC. ou can configure a maximum of eight parameters for each UDF
indLGC. IDEC SmartRelay can show a maximum of three parameters on a
or to change the value. Press
to change its value. Press O to confirm your modifications. Then IDEC SmartRelay
or to select another number and then press
IDEC SmartRelay Manual