IDEC SMARTRELAY User Manual page 63

IDEC SmartRelay's connectors
The term connector refers to all connections and states in IDEC SmartRelay .
The digital I/O status can be '0' or '1'. Status '0' means that the input does not carry a specific
voltage. Status '1' means that the input does carry a specific voltage.
The 'hi' and 'lo' connectors make it easier for you to create the circuit program. 'hi' (high) is
assigned the status '1', and 'lo' (low) is assigned the status '0'.
You do not have to use all of the connectors of a block. The circuit program automatically
assigns the unused connectors a status that ensures proper functioning of the relevant block.
For information on the meaning of the term "block", refer to the topic on "Blocks and block
numbers (Page 52)".
IDEC SmartRelay has the following connectors :
Inputs
Outputs
lo
hi
Memory markers
Shift register bits
Network inputs
Network analog inputs
Network outputs
Network analog outputs
DM: Digital module
AM: Analog module
1)
To make these four connectors available in an IDEC SmartRelay module, you must configure them
in the circuit program with WindLGC V8.0 and download the circuit program to the IDEC SmartRelay.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Connectors
FL1F-H12RCC
FL1F-B12RCC
FL1F-H12RCA
FL1F-B12RCA
FL1F-H12RCE
FL1F-B12RCE
FL1F-H12SCD
Q1 to Q4
Logical '0' signals (off)
Logical '1' signals (on)
Digital memory markers: M1 to M64
Analog memory markers: AM1 to AM64
S1.1 to S4.8
NI1 to NI64
1)
1) NAI1 to NAI32
NQ1 to NQ64
1)
NAQ1 to NAQ16
1)
Programming IDEC SmartRelay
Two groups: I9 to I24
I1 to I4 and
I5 to I8
I1, I2, I3-I6, I7, I8 I9 to I24
AI3, AI4 ...
AI1, AI2
Q5 to Q20
3.1 Connectors
AI1 to AI8 none
AI5 to AI8
none AQ1 to AQ8
51