Writing And Starting The Circuit Program; Selecting Programming Mode - IDEC SMARTRELAY User Manual

3.7 riting and starting the circuit program
The example below shows how to create a program for your circuit design in IDEC
SmartRelay.
3.7.1

Selecting programming mode

hen you connect IDEC SmartRelay to the power supply and switch it on, the display shows
you the main menu of the programming mode:
The first line is highlighted. Press
The IDEC SmartRelay s programming menu is as shown below:
Here you can also move the highlight bar by pressing
and confirm with O .
ou are now in the circuit program window. Press O to enter the program editing mode, and
the cursor appears as a solid s uare at the NE
Confirm with O and IDEC SmartRelay now shows you the first output:
ou are now in programming mode. Press
start to edit your circuit program.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
and confirm with O . IDEC SmartRelay opens the programming menu.
3.7 riting and starting the circuit program
and to move the highlight bar up and down. Move it to
and . Move the highlight bar to
block. The display now shows as follows:
and to select the other outputs. Now you can
Programming IDEC SmartRelay
63