IDEC SMARTRELAY User Manual page 237

Parameters V1 to V4
Another already-programmed function can provide the analog values for the parameters V1
to V4. You can use the actual values of the following functions:
•
Analog comparator (Page 183) (actual value Ax – Ay)
•
Analog trigger (Page 178) (actual value Ax)
•
Analog amplifier (Page 191) (actual value Ax)
•
Analog multiplexer (Page 209) (actual value AQ)
•
Analog ramp control (Page 212) (actual value AQ)
•
PI controller (Page 216) (actual value AQ)
•
Up/down counter (Page 168) (actual value Cnt)
•
Analog filter (Page 229) (actual value AQ)
•
Average value (Page 235) (actual value AQ)
•
Max/Min (Page 231) (actual value AQ)
•
On-delay (Page 132) (current time Ta)
•
Off-delay (Page 136) (current time Ta)
•
On-/off-delay (Page 138) (current time Ta)
•
Retentive on-delay (Page 140) (current time Ta)
•
Interval time-delay relay/Pulse output (Page 142) (current time Ta)
•
Edge-triggered interval time-delay relay (Page 144) (current time Ta)
•
Asynchronous pulse generator (Page 146) (current time Ta)
•
Stairwell light switch (Page 150) (current time Ta)
•
Dual-function switch (Page 152) (current time Ta)
•
Stopwatch (Page 166) (actual value AQ)
•
Analog math (actual value AQ)
•
Frequency trigger (Page 175) (actual value Fre)
Select the required function by the block number. For information on parameter defaults, refer
to the On-delay (Page 132) topic.
Note
If the analog value for parameter V1, V2, V3 or V4 is derived from another already-
programmed function whose actual value exceeds the value range for V1 to V4, IDEC
SmartRelay will display the limit value -32768 if the value is less than the lower range or
32767 if the value is greater than the upper range.
Parameters p (number of decimals)
Parameter p applies only to the display of Value1, Value2, Value3, Value4 and AQ in a
message text.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
IDEC SmartRelay functions
4.4 Special functions list - SF
225