Programming IDEC SmartRelay
3.4 The four golden rules for operating IDEC SmartRelay
Rule 2: Outputs and inputs
•
Always create your circuit program by working from the output to the input.
•
You can connect an input to several outputs, but not the same output to several inputs.
•
Within the same program path you cannot connect an output to an upstream input. You
can use markers or outputs for such internal recursions.
Rule 3: Cursor and cursor movement
The following applies when you edit a circuit program:
•
You can move the cursor when it appears as a solid square:
– Press , ,
– Press OK to change to select connector/block.
– Press ESC to exit programming mode.
•
You select a connector/block when the cursor appears as a solid square:
– Press
– Confirm with OK.
– Press ESC to return to the previous step.
Rule 4: Planning
•
Before you start to create a circuit program, first create a design on paper or program
IDEC SmartRelay directly using WindLGC.
•
IDEC SmartRelay can only save complete and faultless circuit programs.
58
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
or
to move the cursor in the circuit program.
or
to select a connector or a block.
IDEC SmartRelay Manual