IDEC SMARTRELAY User Manual page 42

IDEC SmartRelay installation and wiring
2.3 Wiring IDEC SmartRelay
Sensor characteristics for IDEC SmartRelay
Input voltage (Signal 0)
Input current (Signal 0)
Input voltage (Signal 1)
Input current (Signal 1)
Input voltage (Signal 0)
Input current (Signal 0)
Input voltage (Signal 1)
Input current (Signal 1)
Note
FL1F-H12RCC/B12RCC contains two groups of four inputs, for a total of eight. Within each
group, you must operate all inputs on the same phase. Different phases are only possible
between the groups.
Example: I1 to I4 on phase L1, I5 to I8 on phase L2.
You must not connect the inputs of the FL1F-M08C2R2 to different phases.
Sensor connections
Connecting glow lamps and two-wire proximity switches (Bero) to FL1F-H12RCC/B12RCC or
FL1F-M08C2R2 (AC)
The figure below shows how you connect a switch with a glow lamp to IDEC SmartRelay. The
current that flows through the glow lamp allows IDEC SmartRelay to detect a "1" signal even
though the switch contact is not closed. If, however you use a switch that has the glow lamp
fitted with a power supply, this response does not occur.
30
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
FL1F-H12RCE
FL1F-B12RCE
I3 ～ I6 I1,I2,I7,I8
< 5 V DC < 5 V DC < 5 V DC
< 0.88mA < 0.07mA < 0.9mA
> 8.5 V DC > 8.5 V DC > 12 V DC
> 1.5mA > 0.12mA > 2.1mA
FL1F-M08B2R2
< 5 V DC
< 0.88mA
> 8.5 V DC
> 1.5mA
FL1F-H12SCD
I3 ～ I6 I1,I2,I7,I8
< 5 V DC < 5 V AC
< 0.07mA < 1.2mA
> 12 V DC > 12 V AC
> 0.18m > 2.6mA
FL1F-M08B1S2
< 5 V DC < 5 V AC
<0.88mA < 1.1mA
> 12 V DC > 12 V AC
> 2.1mA > 2.63mA
FL1F-H12RCA FL1F-H12RCC
FL1F-B12RCA FL1F-B12RCC
AC DC AC
< 5 V DC < 40 V AC
< 1.2mA < 0.05mA
> 12 V DC > 79 V AC
> 2.6mA > 0.08 mA
FL1F-M08D2R2 FL1F-M08C2R2
AC DC AC
< 5 V DC < 40 V AC
< 1.1mA < 0.05mA
> 12 V DC > 79 V AC
> 2.63mA > 0.08 mA
IDEC SmartRelay Manual
DC
< 30 V DC
< 0.06mA
> 79 V DC
> 0.13mA
DC
< 30 V DC
< 0.06mA
> 79 V DC
> 0.13mA