IDEC SMARTRELAY User Manual page 99

SmartRelay holds the values of the analog outputs at their last values. A setting of
means that IDEC SmartRelay sets the analog output values to specific values, which you
can configure.
values of the analog outputs change as well, depending on the setting.
7. Select the desired output setting: Press
8. Confirm your entry: Press O .
Defining a specific analog output value
To output a specific analog value at the analog outputs, follow these steps:
1. Move the cursor to
2. Confirm
The display shows:
3. Select a desired analog output and press O .
4. Enter a specific output value for the analog output.
5. To confirm your entry, press O .
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
ou can select either
hen IDEC SmartRelay changes from RUN mode to STOP mode, the
: Press
: Press O
3.7
or . The default setting is
or .
or
Programming IDEC SmartRelay
riting and starting the circuit program
which means that IDEC
87