IDEC SMARTRELAY User Manual page 107

Configuring the network settings
IDEC SmartRelay provides a menu command for configuring network settings.
1. Switch IDEC SmartRelay to programming mode.
2. Press
3. Press O to confirm
4. Press
5. Press O to confirm
6. The display now shows the default IP address of your IDEC SmartRelay. To change the
setting, press O .
move the cursor to a position where you want to modify the number, then press
increase or decrease the number. To confirm your change, press O .
IDEC SmartRelay stores up to four addresses that you set previously. To view your last
settings, press
down list, for example:
O to comfirm.
7. Press
above. To change the setting, press O .
s uare, press
number, then press
press O .
8. Press
To change the setting, press O .
press
press
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
or to move the cursor to
or to move the cursor to
hen the cursor appears in a flashing solid s uare, press
to move the cursor to the
ou can press or to select a previously configured address in the list, and then press
or to move to the subnet mask setting. The default subnet mask is as shown
or to move the cursor to a position where you want to modify the
or
to move to the gateway address setting. The default gateway is as shown above.
or to move the cursor to a position where you want to modify the number, then
or to increase or decrease the number. To confirm your change, press O .
3.8 Configuring additional functions for IDEC SmartRelay
.
.
.
. IDEC SmartRelay displays the following view:
symbol, and then press O to open a drop-
hen the cursor appears in a flashing solid
to increase or decrease the number. To confirm your change,
hen the cursor appears in a flashing solid s uare,
Programming IDEC SmartRelay
or to
or to
95