Connecting The Ethernet Interface - IDEC SMARTRELAY User Manual

2.3.5

Connecting the Ethernet interface

Base modules and text display are equipped with a 10/100 Mbit/s Ethernet RJ45 interface.
Requirements for the network cable
Use a shielded Ethernet cable to connect to the Ethernet interface. To minimize
electromagnetic interference, make sure you use a standard Category 5 shielded twisted-pair
Ethernet cable with a shielded RJ45 connector on each end.
Connecting
You connect the FE terminal to earth ground, and connect a network cable to the Ethernet
interface.
①
②
③
Ethernet status LED
LED type
Status LED
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Earth ground
Ethernet cable, for connecting to the Ethernet interface
Ethernet status LED
Color
Flashing orange
Steady green
IDEC SmartRelay installation and wiring
Description
IDEC SmartRelay is receiving/sending data across Ethernet.
IDEC SmartRelay is already connected to Ethernet.
2.3 Wiring IDEC SmartRelay
43