IDEC SMARTRELAY User Manual page 94

Programming IDEC SmartRelay
3.7 riting and starting the circuit program
Enabling/disabling retentivity
To decide whether you want to retain your current data after a power failure or not, follow
these steps:
1. Move the cursor to -/ : Press
2. Switch to editing mode: Press O
3. Move the cursor to the retentivity setting: Press
4. Select the retentivity setting: Press
The display now shows:
5. Confirm your entries with O .
Note
For further information on the protection mode, refer to the topic Parameter protection (Page
125) .
For further information on retentivity, refer to the topic Retentivity (Page 125) .
ou can modify the protection mode and retentivity setting only in programming mode. This
is not possible in parameter assignment mode.
IDEC SmartRelay displays protection mode (
where you can actually change these settings.
Verification of the circuit program
ou have now completed the program branch for
output
browse the circuit program that is, press
between the inputs at a block.
82
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
1. ou can once again view the circuit program on the display. Use the keys to
or
or
or
or - ) and retentivity ( R or / ) settings only
1 and IDEC SmartRelay shows you the
or to move from block to block, and to move
IDEC SmartRelay Manual