Labeling Idec Smartrelay; Wiring Idec Smartrelay - IDEC SMARTRELAY User Manual

IDEC SmartRelay installation and wiring
2.3 iring IDEC SmartRelay
2.2.4

Labeling IDEC SmartRelay

The rectangular areas on the IDEC SmartRelay modules are intended for labeling.
L1
X10
In the case of expansion modules, you can use the rectangular areas for labeling the inputs
and outputs, for example. In this connection, you can enter a delta factor of 8 for the inputs
or 4 for the outputs if the Base Module already has 8 inputs or 4 outputs.
2.3 iring IDEC SmartRelay
ire IDEC SmartRelay using a screwdriver with a 3 mm blade.
ou do not need to wire ferrules for the terminals. ou can use conductors fulfilled the
following re uirements:
Cross-sections of up to the following thicknesses:
Conductor material: Cu
Insulation temperature rating: 75 C
Tightening tor ue: 0.5 Nm to 0.6 Nm or 4.5 in-lbf to 5.3 in-lbf.
Recommended ferrules
Ferrules order No.
For 1-cable connection
Cross-section
26
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
N I1 I2 I3 I4 I5 I6 I7 I8
AC/DC 100...240V INPUT 8xAC/DC
2
1 2.5 mm
2
2 1.5 mm for each second terminal chamber
A G
2
mm
0.3 22
0.5 20
0.75 18
1.25 18
2.0 16
Recommended
crimping tool
Phoenix Contact
Blade Terminals
Ferrule type No.
AI0,5-10 H
AI0,5-10 H BT1.25-10-1
AI0,75-8G
BT1.25-10-1
AI1,5-8B
AI2,5-8BU
CRIMPFO A 3
NIC HIFU NIC HIFU
Insulated Pin Terminals
type No. type No.
TGN-TC-1.25-11T
BT2-9-1
BT2-9-1
NH1
NH61
IDEC SmartRelay Manual
-
-
NH11
NH32
NH65