IDEC SMARTRELAY User Manual page 97

1. Switch IDEC SmartRelay to programming mode.
(As a reminder, refer to the topic The four golden rules for operating IDEC SmartRelay
(Page 57) ).
2. To select
3. To confirm
4. To select
5. To confirm
(If re uired, enter your password and confirm with O .)
6. Press O in the circuit program window, and the cursor now appears as a solid s uare.
7. Move the cursor to the
8. Move the cursor to B2, the input of
9. Now set the blank connector at output
Result: IDEC SmartRelay deletes block B2 and all blocks that connect to B2 (in this case,
block B1) from the circuit.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
: Press or
: Press O
: Press or
: Press O
1 block and then press O .
Select the blank connector: Press
Apply the blank connector: Press O
Programming IDEC SmartRelay
3.7 riting and starting the circuit program
1, and confirm with O .
1 instead of block B2:
or
85