Menu Access Security - IDEC SMARTRELAY User Manual

Security

10.3 Menu access security

2. Confirm
3. Move the cursor to
4. Confirm
IDEC SmartRelay shows the following display:
By default, the card is unprotected.
5. Move the cursor to
6. Confirm your selection by pressing O .
Note
The protection function applies only to the card you must Copying data from IDEC
SmartRelay to the card (Page 270) the circuit program to the card in a separate action at
power-on.
ou can always change the status of protection function disabled to protection function
enabled.
A status change from protection function enabled to protection function disabled is only
possible if the card does not contain a circuit program.
10.3 Menu access security
IDEC SmartRelay provides two access levels, administrator and operator, to limit access to
specific menus in programming mode. ou can change IDEC SmartRelay s access level from
administrator to operator or from operator to administrator. For more information about
switching between the access levels, refer to Section Configuring menu access protection for
IDEC SmartRelay (Page 59) .
276
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
with O .
: Press or
with O .
: Press or
IDEC SmartRelay Manual