Writing And Starting The Circuit Program; Selecting Programming Mode - IDEC FL1E-H12RCA User Manual

3.6 Writing and starting the circuit program

After you have designed a circuit, you want to write it to your
IDEC SmartRelay. The small example below shows how to
do this.
3.6.1

Selecting programming mode

You have connected IDEC SmartRelay to the power supply
and switched it on. The display now shows you the message:
No Program
Press ESC
Switch IDEC SmartRelay to programming mode by pressing
ESC. This will take you to the main menu of IDEC
SmartRelay:
>Program..
Card..
Setup..
Start
The first character in the first line is the ">" cursor. Press
and
"Program.." and confirm with OK. IDEC SmartRelay opens
the programming menu.
>Edit..
Clear Prg
Password
Msg Config
Here you can also move the ">" cursor by pressing
Move the ">" cursor to "Edit.." and confirm with OK.
>Edit Prg
Edit Name
AQ
Memory?
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
to move the ">" cursor up and down. Move it to
Programming IDEC SmartRelay
IDEC SmartRelay's main menu
IDEC SmartRelay's programming
menu
The Edit menu of IDEC SmartRelay
and .
69