Configuring IDEC SmartRelay
5.1 Selecting parameter assignment mode
Press ESC to change from RUN to parameter assignment
mode:
Mo 09:00
2008-05-26
Note
The following applies to earlier device versions up to FL1A:
•
You open parameter assignment mode by pressing
ESC+OK.
IDEC SmartRelay changes to parameter assignment mode
and opens the parameter assignment menu:
>Stop
Description of the four menu items of the parameter assignment
menu
•
Stop
You select this command to stop your circuit program and
thus change to the main menu of programming mode. To do
so:
1. To move the '>' cursor to 'Stop':
2. To confirm 'Stop':
>No
3. To move the '>' cursor to 'Yes':
4. To confirm 'Yes':
234
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Set Param
Set..
Prg Name
Stop Prg
Yes
...Press
ESC
Press
Press OK
Press
Press OK
IDEC SmartRelay Manual
or
or