Time Response; Idec Smartrelay Manual - IDEC FL1E-H12RCA User Manual

IDEC SmartRelay functions
Connector X at SF inputs
SF inputs connected to connector x are set low. That is, the
inputs carry a 'lo' signal.
Parameter inputs
At some of the inputs you do not apply any signals. You
configure the relevant block values instead. Examples:
• Par (Parameter):
This input will not be connected. Here, you set the
relevant block parameters (times, on/off thresholds etc.).
• No (Cam):
This input will not be connected. Here, you configure the
time patterns.
• P (Priority):
This is an open input. Here, you define priorities and
specify whether a message is to be acknowledged in
RUN.
4.3.2

Time response

Parameter T
At some of the SFs it is possible to configure a time value T.
When you preset this time, note that your input values are
based on the timebase set:
Timebase
s (seconds)
m (minutes)
h (hours)
B1
T
122
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
seconds :
minutes :
Setting a time T of 250 minutes:
+
Unit in hours h:
=04:10h
04:00 hours
00:10 hours
=
_ _ : _ _
1
/ seconds
100
seconds
hours : minutes
240 minutes
+10 minutes
250 minutes
IDEC SmartRelay Manual