Rule 3
Cursor and cursor movement
The following applies when you edit a circuit program:
•
You can move the cursor when it appears in the form of
an underscore:
-
-
-
•
You select a connector/block
when the cursor appears as a solid square
-
-
-
Rule 4
Planning
•
Before you start to create a circuit program, you should
either first create a design on paper or program IDEC
SmartRelay directly using WindLGC.
•
IDEC SmartRelay can only save complete and faultless
circuit programs.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Press
,
,
or
program.
Press OK to change to "Select connector/block".
Press ESC to exit programming mode.
Press
or
to select a connector or a block.
Confirm with OK.
Press ESC to return to the previous step.
Programming IDEC SmartRelay
to move the cursor in the circuit
67