IDEC FL1E-H12RCA User Manual page 265

Assigning a security function
To assign a circuit program and copy protection function to
the memory cartridge or combined memory/battery
cartridge, open the programming mode and select "Card".
1. Switch IDEC SmartRelay to programming mode (ESC /
>Stop).
2. Select the 'Card' command:
3. To apply 'Card':
4. Move the '>' cursor to 'CopyProtect':
5. To apply 'CopyProtect':
IDEC SmartRelay shows the following display:
The current protection setting is shown in the bottom line.
This function is disabled by default ("No": disabled).
Enabling the security function
To set the security function:
1. Move the '>' cursor to 'Yes':
2. Confirm 'Yes':
IDEC SmartRelay shows the following display:
Note
This only generates a circuit program and copy protection for the
memory cartridge or combined memory/battery cartridge; the circuit
program itself must be copied separately from IDEC SmartRelay to
the memory cartridge or combined memory/battery cartridge. (This
copy can be done at power-on. See chapter 6.4).
You can always change the "No" status (security function disabled)
to "Yes" (security function enabled).
A status change from "Yes" (security function enabled) to "No"
(security function disabled) is only possible if the memory cartridge
or combined memory/battery cartridge does not contain a circuit
program.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
IDEC SmartRelay memory and battery cartridge (card)
>No
Yes
CopyProtect:
No
>No
Yes
CopyProtect:
Yes
Press or
Press OK
Press or
Press OK
Press or
Press OK
251