Defining a specific analog output value
To output a specific analog value at the two analog outputs:
9. Move the '>' cursor to 'Defined':
10.Confirm 'Defined':
The display shows:
11.Enter a specific output value for each of the two analog
outputs.
12.To confirm your entry:
3.6.12 Defining the type of analog outputs
Analog outputs can be either 0..10V/0..20mA, which is the
default, or 4..20mA.
To define the type of analog outputs, follow these steps
starting from the programming menu:
1. Move the ">" cursor to 'Edit..':
2. Select 'Edit':
3. Move the ">" cursor to 'AQ':
4. Select 'AQ':
5. Move the ">" cursor to 'AQ type':
6. Select 'AQ type':
IDEC SmartRelay shows the following display, for example:
The defined type for each analog channel is shown. To
change the type, continue as follows
7. Move to the AQ
that you want to change.
8. Select either default (0..10V/0..20mA)
or 4..20mA.
9. Confirm your selection.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
AQ1: 00.00
AQ2: 00.00
AQ1:default
AQ2:4..20mA
Programming IDEC SmartRelay
Press
Press OK
Press OK
Press
Press OK
Press
Press OK
Press
Press OK
Press
Press
Press OK
or
or
or
or
or
or
95