IDEC FL1E-H12RCA User Manual page 165

Note
Because the FL1E-H12SND does not have a real-time clock, the
seven-day time switch function is not available for this version.
Symbol in IDEC
Timing diagram (three examples)
Cam
Cam 1:
Cam 2:
Cam 3:
Functional description
Each seven-day time switch has three cams you can use to
configure a time hysteresis. You specify the on- and off-
times at the Cam parameters. The seven-day time switch
sets the output at a certain on-time, if this is not already set.
The seven-day time switch resets the output at a certain off-
time if you configured an off-time, or at the end of the cycle
if you specified a pulse output. You will cause a conflict if the
on- and off-times you set for the seven-day time switch are
identical, though set on different cams. In this case, cam3
takes priority over cam2, whereas cam2 takes priority over
cam1.
The switching state of the seven-day time switch is
determined by the status of all three cams.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
SmartRelay
Cam
parameters
1, 2, and 3
Par
Output Q
1 2 1 1
Monday Wednesday
Tuesday
Daily
Tuesday
Saturday and Sunday : 16:30 h to 23:10 h
IDEC SmartRelay functions
Wiring
At the Cam parameters, you set the
on- and off-times of the seven-day
time switch for each Cam switch.
Here you also configure the days
and the time-of-day.
You specify whether the timer
pulses on for one cycle when
activated and then reset. The pulse
setting applies to all three cams.
Q is set when the configured cam is
actuated.
1 1
Friday
Thursday
: 06:30 h to 8:00 h
: 03:10 h to 04:15 h
Description
1 3 1 3
Sunday
Saturday
151
Q