IDEC FL1E-H12RCA User Manual page 95

The display shows:
Old: Old:
ZZ
ZZ
New: New:
Clear the password by leaving the input box blank:
3. Confirm the "blank" password:
The password is "cleared", and you are returned to the
programming menu.
Note
This action disables the password prompt, and thus permits access
without a password.
Let the password prompt be deactivated for the time being, in
order to accelerate progress in our further exercises and examples.
Password: Wrong Password!
When the user inputs the wrong password and confirms the
input with OK, IDEC SmartRelay does not open editing
mode, but returns to the programming menu. This repeats
itself over and again until you input the correct password.
Changing IDEC SmartRelay from RUN to STOP mode from the
Text Display
A change from RUN mode to STOP mode from the Text
Display requires password entry if one is assigned. You
must know the existing password if one is assigned. If there
is no password assigned on the IDEC SmartRelay Base
module, the Text Display will not prompt you for password
entry.
To change IDEC SmartRelay from RUN mode to STOP
mode from the Text Display when IDEC SmartRelay is
password-protected, follow these steps:
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Programming IDEC SmartRelay
Press OK
81