IDEC FL1E-H12RCA User Manual page 101

This is the circuit program layout in IDEC SmartRelay:
I1
I2
x
You can see the OR block and the output relay Q1 we have
already used in the first circuit program. The only difference
is the new off-delay block.
Editing the circuit program
Switch IDEC SmartRelay to programming mode.
As a reminder:
1. Switch IDEC SmartRelay to programming mode
(in RUN: Press ESC to enter the parameter assignment
mode. Select the 'Stop' command, confirm with OK, then
move the '>' cursor to 'Yes', and once again confirm with
OK). See Page 66.
2. On the main menu, select "Program"
3. On the Programming menu, select "Edit", confirm with
OK. Next, select "Edit Prg" and confirm with OK.
If required, enter your password at the prompt and
confirm with OK.
You can now modify the current circuit program.
Adding a block to a circuit program
Move the cursor to the B in B1 (B1 is the number of the OR
block):
B1
We now insert the new block at this position. 
Confirm with OK.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
1
x
Par
Q1
Q1
BN
Programming IDEC SmartRelay
This is the new
block
To move the cursor: Press
IDEC SmartRelay shows you the
BN list
Q1
87