Deleting Block Groups - IDEC FL1E-H12RCA User Manual

3.6.9

Deleting block groups

Let us assume you want to delete the blocks B1 and B2 from
the following circuit program (corresponds with the circuit
program in Chapter 3.7.7 ).
Proceed as follows:
1. Switch IDEC SmartRelay to programming mode
(as a reminder, refer to page 66).
2. To select 'Edit':
3. To confirm 'Edit':
(If required, enter your password and confirm with OK.)
4. To select 'Edit Prg':
5. To confirm 'Edit Prg':
6. To move the cursor to the input of Q1; that is, to B2, press
7. Confirm with OK.
8. Now set the connector 'x' at output Q1 instead of block
B2. To do so:
-
-
-
-
Result: Block B2 is deleted, because it is no longer used in
the circuit. This includes all blocks connected to B2. In this
example, block B1 also.
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
B1
I1
I2
x
Par
:
B2 Q1
Select the Co list:
Accept the Co list:
Select 'x':
Apply 'x':
Programming IDEC SmartRelay
B2
Q1
x
Press or
Press OK
Press or
Press OK
Press or
Press OK
Press or
Press OK
93