IDEC FL1E-H12RCA User Manual page 320

Technical data
Line length (shielded and twisted)
Error limit
Digital outputs
Number
Output type
Electrical isolation
In groups of
Control of a digital input
Output voltage
Output current
Short circuit-proof and overload-proof
Short circuit current limitation
Derating
Short circuit-proof cos 1
Short circuit-proof cos 0.5 to 0.7
Parallel output circuit for power increase
Protection of output relay (if desired)
(2)
Switching rate
Mechanical
Electrical
Ohmic load/lamp load
Inductive load
(1): When FL1E-H12SND or FL1B-M08B1S2 are switched on, signal 1 is sent to the
digital outputs for about 50 microseconds. Take this into account, especially when
using devices that react to short pulses.
(2) The maximum switching rate is only dependent on the switching program's cycle
time.
306
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
FL1E-H12SND
10 m
+/- 1.5% at full scale
4
Transistor, current-sourcing
No
Yes
Supply voltage
=
max. 0.3 A
Yes
Approx. 1 A
none; across the entire temperature range
not applicable for this module
not applicable for this module
Not permitted
not applicable for this module
10 Hz
10 Hz
0.5 Hz
IDEC SmartRelay Manual
(1)