Configuring IDEC SmartRelay
IDEC SmartRelay shows the following display:
Contrast
–
.... ....
8. To change the display contrast:
9. To confirm your entry:
To set the display contrast in programming mode:
If you want to set the display contrast in programming mode,
select 'Setup' in the main menu, then menu 'Contrast'. You
can now set the display contrast as described earlier (as of
step 8.).
To set the back light choice in parameter assignment mode:
1. Select parameter assignment mode (see Chapter 5.1.)
2. On the parameter assignment menu,
select 'Set':
3. Confirm 'Set..':
4. On the Set menu, select 'LCD':
5. Confirm 'LCD..':
6. Move the '>' cursor to 'BackLight':
7. Confirm 'BackLight':
8. Move the '>' cursor to 'Default'
or 'AlwaysOn':
The default is that the back light is not on. To set the back
light to always be on, select the 'AlwaysOn' choice.
To set the back light choice in programming mode:
If you want to set the backlight choice in programming mode,
select 'Setup' in the main menu, then menu 'LCD'. You can
now set the back light choice as described earlier (as of step
6.).
Note
The backlight lifetime of the Text Display is 20,000 hours.
242
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
+
IDEC SmartRelay Manual
Press
or
Press OK
Press
or
Press OK
Press
or
Press OK
Press
or
Press OK
Press
or