IDEC FL1E-H12RCA User Manual page 220

IDEC SmartRelay functions
Functional description
In parameter assignment mode, the output is set with a
signal at input En, if the ''Switch' parameter is set to 'On' and
confirmed with OK. Whether the function was configured for
pushbutton or switching action is of no concern here.
The output is reset to '0' in the following three cases:
• After a 1 to 0 transition at input En
• When the function was configured for momentary
pushbutton action, and one cycle has expired since it was
switched on
• When the position 'Off' was selected at the 'Switch'
parameter and confirmed with OK in parameter
assignment mode
If retentivity is not set, output Q is initialized after a power
failure according to your configuration at the "Start"
parameter.
Setting the Par parameter
View in programming mode (example):
1. Select the 'Softkey' function.
2. Select input En and confirm with OK. The cursor is now
positioned below 'Par'.
3. Change to the input mode of 'Par':
Confirm with OK
(the cursor is now positioned to 'On')
B33
On=
Start=On
To change 'Par' to 'Switch' action and the initialization status
after the program start:
4. To select 'Momentary pushbutton' or 'Switch' action:
Press
B33
On/Off
Start=On
206
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
+/
The status is not retentive
The function is set for "momentary
pushbutton" action
Q is set in the first cycle after the
program start
or
+/
The status is not retentive
"Switch" function
Q is reset in the first cycle after the
program start
IDEC SmartRelay Manual