Programming IDEC SmartRelay
To enable/disable automatic S/W Time conversion in
parameter assignment mode:
If you want to enable/disable automatic S/W Time
conversion in parameter assignment mode, select in the
parameter assignment menu 'Set..', then menus 'Clock' and
'S/W Time'. You can now enable/disable automatic S/W
Time conversion.
Enabling summertime/wintertime conversion
You now want to enable this conversion and define or set its
parameters:
1. Move the '>' cursor to 'On':
2. Confirm 'On':
The display shows:
EU
3. Select the desired conversion:
What is shown on the display ?:
•
'EU' represents the start and end of European
summertime.
•
'UK' represents the start and end of summertime in the
United Kingdom.
•
'US1' represents the start and end of daylight saving time
(summertime) in the United States prior to 2007.
•
'US2' represents the start and end of daylight saving time
(summertime) in the United States in 2007 and later
years.
•
'AUS' represents the start and end of Australian
summertime.
•
'AUS-TAS' represents the start and end of Australian/
Tasmanian summertime.
•
'NZ' represents the start and end of New Zealand
summertime.
•
. . : Here you can enter any month, day and time zone
difference.
98
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Press
or
Press OK
Press
or
IDEC SmartRelay Manual