Softkey - IDEC FL1E-H12RCA User Manual

4.4.24 Softkey

Short description
This special function has the effect of a mechanical
pushbutton or switch.
Symbol in IDEC
En
Par
Factory setting
The default parameter setting is switching action.
Timing diagram
IDEC SmartRelay Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Wiring
SmartRelay
Input En
Q
Parameter
Output Q
En
Switch
Q
IDEC SmartRelay functions
Description
Output Q is set with a 0 to 1 transition
of the signal at input En (Enable), and
if 'Switch=On' was confirmed in
parameter assignment mode.
Programming mode:
Selecting the function for pushbutton
action for the duration of one cycle, or
for switching action.
Start: On or off state, initialized at the
first start of the program if
retentivity is disabled.
Retentivity: 
/ = No retentivity
R = The status is retentive.
Parameter assignment mode (RUN
mode):
Switch: Switches the momentary
pushbutton (switch) on or off.
Switches on if En=1 and Switch=On
was confirmed with OK.
205