D-Link DES-3326S Command Line Interface Reference Manual page 45

show port_security
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To display the port security configuration on the entire Switch:
DES-3326S:4#show port_security
Command: show port_security
Port# Admin State Max. Learning Addr. Lock Address Mode
---- ----------- ------------------- -----------------
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
6 Disabled
7 Enabled
8 Disabled
9 Disabled
10 Disabled
11 Disabled
12 Disabled
13 Disabled
14 Disabled
15 Disabled
16 Disabled
17 Disabled
18 Disabled
19 Disabled
20 Disabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r
Refresh
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to display the current portr lock configuration.
show port_security {<portlist>}
This command is used to display the current port lock
configuration of a range of ports.
<portlist> − specifies a range of ports to be viewed.
The port list is specified by listing the lowest Switch
number and the beginning port number on that Switch,
separated by a colon. Then highest Switch number,
and the highest port number of the range (also
separeted by a colon) are specified. The beginning
and end of the port list range are seperated by a dash.
For example, 1:3 would specify Switch number 1, port
3. 2:4 specifies Switch number 2, port 4. 1:3-2:4
specifies all of the ports between Switch 1, port 3 and
Switch 2, port 4 − in numerical order.
None.
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
10 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
1 DeleteOnReset
39