D-Link DES-3326S Command Line Interface Reference Manual page 212

config sntp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNTP settings:
DES-3326S:4#config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to setup SNTP service.
config sntp {primary <ipaddr> | secondary
<ipaddr> | poll-interval <int 30-99999>}
Use this command to configure SNTP service
from an SNTP server. SNTP must be enabled
for this command to function (See enable sntp).
primary − This is the primary server the SNTP
information will be taken from.
<ipaddr> − The IP address of the primary
server.
secondary − This is the secondary server the
SNTP information will be taken from in the event
the primary server is unavailable.
<ipaddr> − The IP address for the secondary
server.
poll-interval − This is the interval between
requests for updated SNTP information.
<int 30-99999> − The polling interval ranges
from 30 to 99,999 seconds.
Only administrator-level users can issue this
command. SNTP service must be enabled for
this command to function (enable sntp).
206