D-Link DES-3326S Command Line Interface Reference Manual page 310

show ospf virtual_link
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To display the current OSPF virtual interface configuration:
DES-3326S:4#show ospf virtual_link
Transit Virtual
Area ID Neighbor Router Interval
----------------------------------------------------------------------------------------------
10.0.0.0 20.0.0.0
Total Entries: 1
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to display the current OSPF virtual
interface configuration.
show ospf virtual_link {<area_id>
<neighbor_id>
This command will display the current
OSPF virtual interface configuration.
<area_id> − A 32-bit number in the form of
an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id> − The OSPF router ID for
the remote area. This is a 32-bit number in
the form of an IP address (xxx.xxx.xxx.xxx)
that uniquely identifies the remote area's
Area Border Router. This is the router ID of
the neighbor router.
None.
Hello Dead
Interval
10 60
Authentication Link
Status
None DOWN
304