D-Link DES-3326S Command Line Interface Reference Manual page 133

config mirror delete
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the mirroring ports:
DES-3326S:4#config mirror port 1:5 delete source port 1:1-1:5 both
Command: config mirror 1:5 delete source 1:1-1:5 both
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to delete a port mirroring configuration|
config mirror port <port> delete source port
<portlist> [rx|tx|both]
This command is used to delete a previously
entered port mirroring configuration.
<port> −This specifies the Target port (the port
where mirrored packets will be sent).
<portlist> − This specifies a range of ports that
will be mirrored. That is, the range of ports in
which all traffic will be copied and sent to the
Target port.
rx − Allows the mirroring of only packets
received by (flowing into) the port or ports in the
port list.
tx − Allows the mirroring of only packets sent to
(flowing out of) the port or ports in the port list.
both − Mirrors all the packets received or sent
by the port or ports in the port list.
Only administrator-level users can issue this
command.
127