D-Link DES-3326S Command Line Interface Reference Manual page 177

config 802.1x reauth ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1x reauthentication for ports 1-18:
DES-3326S:4#config 802.1x reauth mac_based ports 1-18
Command: config 802.1x reauth mac_based ports 1-18
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to configure the 802.1x re-authentication feature of the Switch.
config 802.1x reauth [port_based ports [<portlist|all>] |mac_based ports
[<portlist>|all] {mac_address <macaddr>}]
The config 802.1x reauth command is used to re-authenticate a previously
authenticated device based on either MAC address or port number.
port_based – This instructs the Switch to re-authorize 802.1x function based
only on the port number. Ports approved for re-authorization can then be
specified.
ports <portlist> − Specifies a range of ports. The port list is specified by listing
the lowest Switch number and the beginning port number on that Switch,
separated by a colon. Then the highest Switch number, and the highest port
number of the range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For example, 1:3
specifies Switch number 1, port 3. 2:4 specifies Switch number 2, port 4. 1:3-
2:4 specifies all of the ports between Switch 1, port 3 and Switch 2, port 4 − in
numerical order.
all − Specifies all of the ports on the Switch.
mac_based - This instructs the Switch to re-authenticate 802.1x function for a
device based on MAC address. MAC addresses approved for re-
authentication can then be added to a list of approved MAC addresses. Re-
authentication is approved only for devices with a MAC address that matches
one from the list. Additional restrictions can be added by requiring a match for
both MAC address and port.
<macaddr> - Specify the MAC address to add to the list for MAC based 802.1x
initialization.
Only administrator-level users can issue this command.
171