D-Link DES-3326S Command Line Interface Reference Manual page 149

config link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 of module 1 with group members
ports 5-7 plus port 9:
DES-3226S:4#config link_aggregation group_id 1 master_port 5 ports 5-7,9
Command: config link_aggregation group_id 1 master_port 5 ports 5-7,9
Success.
DES-3226S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to configure a previously created link aggregation group.
config link_aggregation group_id <value> {master_port
<port>|ports <portlist>| state [enable|disable]
This command allows you to configure a link aggregation group
that was created with the create link_aggregation command
above.
<value> − Specifies the group id. The Switch allows up to 6 link
aggregation groups to be configured. The group number identifies
each of the groups.
<port> − Master port ID. Specifies which port (by port number) of
the link aggregation group will be the master port. All of the ports
in a link aggregation group will share the port configuration with
the master port.
<portlist> − Specifies a range of ports that will belong to the link
aggregation group. Ports are specified by entering the lowest port
number in a group, and then the highest port number in a group,
separated by a dash such as 1-3. Additional ports can be
individually entered by their port number, separated by
commas.So, a port group including the Switch ports 1, 2, and 3
would be entered as 1-3. Ports that are not contained within a
group are specified by entering their port number, separated by a
comma. So, the port group 1-3 and port 26 would be entered as
1-3,26. All ports in the portlist must be on a single Switch unit.
Ports may be listed in only one port aggregation group, that is,
link aggregation groups may not overlap.
state [enable|disable] − Allows you to enable or disable the
specified link aggregation group.
Only administrator-level users can issue this command. Link
aggregation groups may not overlap and must be contained on a
single Switch.
143