D-Link DES-3326S Command Line Interface Reference Manual page 128

config 802.1p default_priority
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1p default priority on the Switch:
DES-3326S:4#config 802.1p default_priority all 5
Command: config 802.1p default_priority all 5
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to specify how to map an incoming packet that has no
802.1p priority tag to one of the Switch's four hardware priority
queues.
config 802.1p default_priority [<portlist>|all] <priority 0-7>
The config 802.1p default_priority command allows you to
specify the 802.1p priority value an untagged, incoming packet
will be assigned before being forwarded to its destination.
<portlist> − Specifies a range of ports to be configured. The port
list is specified by listing the lowest Switch number and the
beginning port number on that Switch, separated by a colon.
Then the highest Switch number, and the highest port number of
the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a dash.
For example, 1:3 specifies Switch number 1, port 3. 2:4 specifies
Switch number 2, port 4. 1:3-2:4 specifies all of the ports between
Switch 1, port 3 and Switch 2, port 4 − in numerical order.
all − Specifies that the config 802.1p default_priority command
will be applied to all ports on the Switch.
<priority 0-7> − Specifies the 802.1p priority value that an
untagged, incoming packet will be given before being forwarded
to its destination.
Only administrator-level users can issue this command.
122