D-Link DES-3326S Command Line Interface Reference Manual page 160

config router_ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set up static router ports:
DES-3326S:4#config router_ports default add 2:1-2:10
Command: config router_ports default add 2:1-2:10
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to configure ports as router ports.
config router_ports <vlan_name 32>
[add|delete] <portlist>
This command allows you to designate a range
of ports as being connected to multicast-
enabled routers. This will ensure that all packets
with such a router as its destination will reach
the multicast-enabled router − regardless of
protocol, etc.
<vlan_name 32> − The name of the VLAN on
which the router port resides.
<portlist> − Specifies a range of ports that will
be configured as router ports. The port list is
specified by listing the lowest Switch number
and the beginning port number on that Switch,
separated by a colon. Then the highest Switch
number, and the highest port number of the
range (also separated by a colon) are specified.
The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies
Switch number 1, port 3. 2:4 specifies Switch
number 2, port 4. 1:3-2:4 specifies all of the
ports between Switch 1, port 3 and Switch 2,
port 4 − in numerical order.
Only administrator-level users can issue this
command.
154