D-Link DES-3326S Command Line Interface Reference Manual page 30

enable telnet
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To enable Telnet and configure port number:
DES-3326S:4#enable telnet 23
Command: enable telnet 23
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to enable communication with and
management of the Switch using the Telnet
protocol.
enable telnet <tcp_port_number>
This command is used to enable the Telnet
protocol on the Switch. The user can specify the
TCP or UDP port number the Switch will use to
listen for Telnet requests.
<tcp_port_number> − The TCP port number.
TCP ports are numbered between 1 and 65535.
The "well-known" TCP port for the Telnet
protocol is 23.
Only administrator-level users can issue this
command.
24