The PIM commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config pim
enable pim
disable pim
show pim neighbor
show pim
Each command is listed, in detail, in the following sections.
D-Link DES-3326S Layer 3 Switch CLI Reference
Parameters
[ipif <ipif_name 12>| all ] { hello <sec 1-18724>
| jp_interval <sec 1-18724> | state [ enable |
disable ]}
{ipif <ipif_name 12> | ipaddress
<network_address>}
{ipif <ipif_name 12>}
262
33
PIM C
OMMANDS