D-Link DES-3326S Command Line Interface Reference Manual page 303

config ospf ipif
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To configure OSPF interface settings:
DES-3326S:4#config ospf ipif System priority 2 hello_interval 15 metric
2 state enable
Command: config ospf ipif System priority 2 metric 2 state enable
hello_interval 15
Success.
DES-3326S:4#
D-Link DES-3326S Layer 3 Switch CLI Reference
Used to configure the OSPF interface settings.
config ospf ipif <ipif_name> {area <area_id>|priority
<value>|hello_interval <sec>|dead_interval <sec>|authentication
[none|simple <password>|md5 <key_id>]|metric <value>|state
[enable|disable]}
This command is used to configure the OSPF interface settings.
<ipif_name> − The name of the IP interface.
priority <value> − The priority used in the election of the Designated Router
(DR). A number between 0 and 255.
metric <value> − The interface metric (1 to 65535). Entering a 0 will allow
automatic calculation of the metric.
hello_interval <sec> − Allows the specification of the interval between the
transmission of OSPF Hello packets, in seconds. Between 1 and 65535
seconds can be specified. The Hello Interval, Dead Interval, Authorization
Type, and Authorization Key should be the same for all routers on the same
network.
dead_interval <sec> − Allows the specification of the length of time between
the receipt of Hello packets from a neighbor router before the selected area
declares that router down. An interval between 1 and 65535 seconds can be
specified. The Dead Interval must be evenly divisible by the Hello Interval.
<password> − A case-sensitive password.
<key_id> − A previously configured MD5 key ID (1 to 255).
metric <value> − This field allows the entry of a number between 1 and 65,535
that is representative of the OSPF cost of reaching the selected OSPF
interface. The default metric is 1.
Only administrator-level users can issue this command.
297