D-Link DES-3326S Command Line Interface Reference Manual page 287

Virtual Interface Configuration
Transit Virtual
Area ID Neighbor Router Interval Interval
----------- ---------------
10.0.0.0 20.0.0.0
10.1.1.1 20.1.1.1
Total Entries : 2
OSPF Area Aggregation Settings
Area ID Aggregated
Network Address
--------------- ------------------
Total Entries : 0
OSPF Host Route Settings
Host Address Metric
--------------- ------
10.3.3.3 1
Total Entries : 1
DES-3326S:4#
create ospf area
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To create an OSPF area:
D-Link DES-3326S Layer 3 Switch CLI Reference
Hello Dead
-------- --------
10 60
10 60
LSDB Advertise
Type
-------- ---------
Area ID TOS
--------------- ---
10.1.1.1 0
Used to configure OSPF area settings.
create ospf area <area_id> type [normal|stub]
{stub_summary [enable|disable]|metric
<value>}]
This command is used to create an OSPF area
and configure its settings.
<area_id> − The OSPF area ID.
type − The OSPF area mode of operation − stub
or normal.
stub_summary − enables or disables the OSPF
area to import summary LSA advertisements.
<value> − The OSPF area cost between 0 and
65535. The default is 0.
Only administrator-level users can issue this
command.
Authentication Link
Status
-------------- ------
None DOWN
None DOWN
281